EWFS Inside PL UP is a flush-mounted receiver serving as a motor control unit for 24 V sun shading drives.

Specific

The system receives commands from all EWFS transmitters and sensors and is directly connected with your sun shading drive and controls it floating. Suitable for 24 V DC sun shading drives.

Unobtrusive

The receiver is unobtrusively built into a flush-mounted box.

Networked

You can control your drive with your central control system and your EWFS transmitter.

  • PL: Permanent mode for controlling fabric products
  • Can be used to control a double-glazed facade venetian blind with a DCD22E motor (soft tilt)
  • 24 V DC is supplied via an available central control line, a floor distribution control or a power supply unit
  • Control possible with a sun shading control system, e.g. Wisotronic, via central input (24 V DC)
  • Compact design enables installation in a flush-mounted box
Article number: 1002886

Description

Value

Operating voltage

24 V DC

Control voltage

24 V DC

Output

24 V DC

Switching capacity per drive

max. 3 A / 72 W

Transmission frequency

433,92 MHz

Logic behaviour

PL

Run time up/down

3 minutes

Degree of protection

IP 20

Safety class

III

Type of installation

Flush-mounted (UP)

Width

49 mm

Height

49 mm

Depth

30 mm

Junction box without terminals

Power supply unit for supplying extra low-voltage consumer loads

Power supply unit for supplying extra low-voltage consumer loads

Power supply unit for supplying extra low-voltage consumer loads

Power supply unit for supplying extra low-voltage consumer loads

Device for the operation of motor control units of up to four facades or groups via a higher-level central control unit or for facades on an individual floor via operation on different storeys