Stored
Saves the last setting: the set brightness/dimming level is retained when the system is switched off and set when the system is switched on again.
Protecting
Extends the service life: soft-start and soft-stop at the zero crossing protects the connected power consumer.
Infinitely variable
Well dosed: controls fans from different manufacturers with and without flaps.
- Controlling up to two power consumers (230 V)
- Automatic load detection for ohmic, inductive or capacitive loads
- The set brightness is retained when the system is switched off and set when the system is switched on again
- Controls and regulates speed of fan drives from different manufacturers
- Control of fans with supply air flaps is possible
- Required connecting lines:
- 230 V connecting line for supplying the connected 230 V power consumers
- 24 V connecting line from external power supply unit for supplying the actuator
- 4-wire bus cable (climabus)
- Connection of conventional push buttons to local individual and group operation (24 V)
- Allocation of connected sensors when commissioning via control panel or WAREMA climatronic® studio
- The operating mode of the connected local push buttons is automatically adjusted to the set product types.
Description
Value
Operating voltage
24 V DC
Output
2 x 230 V AC
Switching capacity per drive
200 VA at 230 V AC
(horizontal installation)
300 VA at 230 V AC
(vertical installation)
Degree of protection
IP 30
Safety class
I
Type of installation
DIN rail-mounted (REG)
Subassembly width
6 MW
Power supply unit for supplying extra low-voltage consumer loads
Power supply unit for supplying extra low-voltage consumer loads