The Piccolo ZL UP motor control unit for flush mounting transmits move commands from central control units to sun shading products with 230 V drives. The motor control unit receives the 24 V DC operating voltage via a control line directly from a floor distribution control or an external power supply unit.

Connecting

The motor control unit runs 230 V drives of sun shading products with a time mode.

Grouped

Motor groups of any size: motor control units can be combined across facades via the control line and operated together with one push button.

Practical

The motor control unit and the central control unit are connected by the control line. The control voltage of 24 V facilitates the use of a light current conductor (J-Y(St)Y).
  • Directly controls a 230 V sun shading drive via the sun shading control system and an on-site push button.
  • Multiple motor control units can be combined into a group and controlled jointly with one push button.
  • Push button operating mode: Time mode
  • ZL: In time mode, the MSE enters lock mode after the push button is pressed for approx. 2 seconds. Operating the push button for a shorter duration generates a tilting impulse (on slat products).
  • The operating voltage for the MSE is generated in an external power supply unit or in an external floor distribution control standard.
 Article number: 1002416

Description

Value

Operating voltage

230 V AC

Control voltage

24 V DC

Output

230 V AC

Switching capacity per drive

700 VA with 230 V AC

Logic behaviour

ZL

Degree of protection

IP 20

Safety class

II

Type of installation

Flush-mounted (UP)

Width

48.5 mm

Height

48.5 mm

Depth

20.4 mm

Junction box without terminals

Power supply unit for supplying extra low-voltage consumer loads

Power supply unit for supplying extra low-voltage consumer loads

Power supply unit for supplying extra low-voltage consumer loads

Power supply unit for supplying extra low-voltage consumer loads