MSE Inside 6 REG
- Back
- Home
- Motor control units for 24 V drives
- MSE Inside 6 REG
Product description
Multiple drives
The motor control unit transfers commands from your central control unit or the local push button to up to six 24 V sun shading drives.
Logical
Time mode or permanent mode: using the push button, you can select the right operating mode for the product type.
Protective
The locking input locks your sun shading product when the window is open. This means you can automatically and reliably protect your sun shading product from damage.
Features
- Direct control of up to six 24 V sun shading drives/window drives via a sun shading control system and a local push button.
- Multiple motor control units can be combined into a group and controlled jointly with one push button.
- The operating mode of the Push button can be switched between time mode and permanent mode.
- ZL: In time mode, the MSE enters lock mode after the push button is pressed for approx. 2 seconds. Operating the push button for a shorter duration generates a tilting impulse (on slat products).
- PL: In permanent mode, the MSE enters lock mode immediately after the push button is pressed (for fabric products/roller shutters).
- “Fan out” program (complete slat tilting after stop or 3 minutes run time) in order to ensure the correct position of the slats.
- Locking input allows the sun shading drive to be locked, e.g. when a window is opened.
Technical data
Description
Value
Operating voltage
24 V DC
Control voltage
24 V DC
Output
6 x 24 V DC
Switching capacity per drive
3 A at 24 V DC
Logic behaviour
ZL PL
Degree of protection
IP 30
Safety class
III
Type of installation
DIN rail-mounted (REG)
Subassembly width
12 MW
Additional equipment
Power supply unit for supplying extra low-voltage consumer loads
Power supply unit for supplying extra low-voltage consumer loads
Power supply unit for supplying extra low-voltage consumer loads
Power supply unit for supplying extra low-voltage consumer loads
-
Document name
Action
File type
File size