The Compact motor control unit with integrated power supply unit transmits move commands from central control units to up to 6 sun shading products with 230 V drives. The installation is either surface-mounted or in-line. The unit generates the 24 V DC control voltage for controlling the motor control unit with a push button or the sun shading control system.

Multiple drives

The motor control unit runs up to six 230 V AC drives of your sun shading products.

Adjustable

Time mode and permanent mode: you can set the corresponding logic behaviour directly on the device.

Practical

The motor control units and your central control unit are connected by a control line. The control voltage of 24 V facilitates the use of a light current conductor (J-Y(St)Y).

  • Direct control of four 230 V sun shading drives via a sun shading control system and a local push button.
  • Multiple motor control units can be combined into a group and controlled jointly with one push button.
  • The operating mode of the Push button can be switched between time mode and permanent mode.
  • ZL: In time mode, the MSE enters lock mode after the push button is pressed for approx. 2 seconds. Operating the push button briefly generates a tilting impulse (on slat products).
  • PL: In permanent mode, the MSE enters lock mode immediately after the push button is pressed (for fabric products/roller shutters).
Article number: 2016486

Description

Value

Operating voltage

230 V AC

Control voltage

24 V DC

Output

4 x 230 V AC

Switching capacity per drive

500 VA with 230 V AC

cos Ï† = 0.6

Logic behaviour

ZL PL

Degree of protection

IP 30

Safety class

I

Type of installation

Surface-mounted (AP)

Width

158 mm

Height

180 mm

Depth

60 mm